More pictures of the latest myPhone 2.0 case design.
This version has a deeper case, and was printed at a simple angle, the previous attempt ended up warping, so I hope these changes will keep it flat. It also has a slot in the bottom end to take an iPod connector, which carries power, USB, stereo line level output etc. an antenna mounting hole at the top, and a retaining clip design to hold the LCD in place.
This contains 2.6 cubic inches of ABS plastic, and used 1.4 cubic inches of support material, which costs about $40 in materials and took 8 hours to print at Techshop.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.